TAIT T2020 SOFTWARE MANUAL
This manual is also available from the Repeater Builder Site: This details the 15 pin connector on the T2000-A80 line interface kit: Generic PTT circuit Version with isolation
TAIT T2020 SOFTWARE SOFTWARE
The computer then outputs theĪudio signal from the software into the mic input of the radio. Using RTS signal from the PC to trigger the PTT (Tx).
Pinout to wire an RJ12 plug and replace the Mic for data communications: RJ12 Plug and Socket Viewed from the Front Straight through cable on many such devices without failures, however there are no guarantees. USB to serical devices tend to operate at the lower range of the RS232 voltage range. To transistor level, to TTL components designed to operate a 5 volts. Note: There is some concern that this scheme connects RS232c voltage levels, that can be a high as 24 volts The schematic of the front control panel showing the microphone jack is here: Rear Power and Spearer Plug Power and Spearer Plug pinouts This site gives a good explanation on the identification of Tait Radios: I haveĪlso experimented with T2000 series radios for Allstar and APRS. T2000's on two meter and 70 cm to communicate on the local repeaters. With the T2000 series so I am no expert on Tait radios in general. Here is the collection of Tait T2000 radios I am using.
0 kommentar(er)
